Page 11;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 57610
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
;**9"83%MV7&8%T"8*
MIGLO6-%%G&%/(*]*8$%9,5,3*%$&%G("55*(=%
UI%MIG%SPNJ%EJIIT%eIPELMR%IM%RKIPMU1%%%
G."#%#$("83%$("55*(%2**9#%T"8*%,'$&5,$"4,77V%
).*8%#$&//"83%,89%(*#$,($"831
1. With Trimmer running, release Trigger
and allow Trimmer to stop fully, then press
Trigger to restart. Line will be fed out and
cut to proper length by Line Cutter.
2. If Trimmer is not cutting correctly, Spool may
be tangled. Remove Spool and rewind Line.
3. To manually feed Line, unplug the Power Cord,
press the Line Outlet Button on Spool Housing,
and pull out the Line slightly. Keep pushing
the Button and pulling the Line out until
the Line reaches the desired length.
T"8*%I'$7*$%
S'$$&8%
E/&&7%
e&'#"83
K*/7,4"83%MV7&8%T"8*
1. Press tabs on Spool Cover, remove Spool Cover,
then remove Spool from Spool Housing.
E/&&7%
O&]*(
2. Remove old line from Spool.
3. Clean interior of Spool Housing with soft cloth.
4. Insert end of Nylon Line (up to 16 feet)
into Line Insertion Hole.
T"8*%L8#*($"&8%
e&7*
5. Wrap Line onto Spool in neat, straight rows, under
tension, following arrow direction on top of Spool.
6. Leave approximately 4" of line unwound and
insert it into the cleat at the top end of Spool.
Then repeat for the lower end of Spool.
14
O7*,$
7. Insert Spool partway into Spool Housing,
insert line ends through Line Outlet in
housing, and pull line ends snug.
T"8*%
I'$7*$#
8. Insert Spool fully and replace Spool Cover.
To Next Page
Loading...
