Page 9For technical questions, please call 1-888-866-5797.Item 56877
SAFETYOPERATIONMAINTENANCE SETUP
Attach Gun Holder
1. Position Gun Holder (3) against left
side of Handle (1) as shown.
2. Align holes in Gun Holder with holes in Handle.
3. Attach Gun Holder to Handle with two Screws (4).
Gun
Holder (3)
Screw (4)
Handle (1)
Attach Storage Panel and Cord Hook
1. Position the Storage Panel (6) against
right side of Handle (1) as shown.
2. Align holes in the Storage Panel
with holes in the Handle.
3. Attach the Storage Panel to the
Handle with two Screws (4).
4. Place the Cord Hook Bracket (11) against the right
edge of the Handle, aligning it with the hole.
5. Place the Cord Hook (12) over its Bracket
with the end pointing upwards.
6. Secure the Cord Hook to the Bracket and
Handle using the Cord Hook Screw (13).
Storage
Panel (6)
Handle (1)
Screw (4)
Cord Hook
Bracket (11)
Cord
Hook (12)
Cord Hook
Screw (13)
Connect High-Pressure Hose
1. Connect High-Pressure Hose (41) to connection on
back of Pressure Washer by pushing Hose in as
far as it will go, then threading coupler on tightly.
2. Connect High-Pressure Hose to connection under
Gun Handle (61) by pushing Hose in as far as
it will go, then threading coupler on tightly.
High
Pressure
Hose (41)
Gun
Handle
(61)
To Next Page
Loading...