Page 11;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 57656
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
R*8*(,7%I/*(,$"83%L8#$('4$"&8#
GI%JK6!6MG%6T6OGKLO%EXIOe%FMU%U6FGX-%%G*#$%R(&'89%;,'7$%O"(4'"$%
L8$*(('/$*(%aR;OLc%+*2&(*%*,4.%'#*1%%G.*%R;OL%9&*#%8&$%/(&$*4$%,3,"8#$%*7*4$("4,7%
#.&4^%9'*%$&%4&8$,4$%)"$.%+&$.%4"(4'"$%4&89'4$&(#%&(%,%2,'7$%"8%,8V%)"("83%#'//7V"83%"8%$."#%9*Z"4*1%%U&%8&$%
,7$*(%&(%9"#,+7*%$.*%R;OL1%%U&%8&$%'#*%,8%*[$*8#"&8%4&(91%%%
This unit is intended for light to moderate cleaning. It is not intended for paint stripping or deep concrete cleaning.
1. Uncoil High-Pressure Hose completely. U&%8&$%'#*%
J(*##'(*%Q,#.*(%"2%X&#*%"#%^"8^*9%&(%7&&/*91
2. The Spray Gun includes a trigger safety
lock that locks from the left side.
• Push Safety Lock in from the right
side to unlock Trigger.
E,2*$V%
T&4^
3. Point Spray Gun in safe direction, press Trigger
to release all pressure, then release Trigger.
4. Plug GFCI into dedicated, grounded
120V outlet, then press the K6E6G
button to ensure proper operation.
5. Turn on water supply.
6. Turn Power Switch to ON position.
M&$*- If the unit does not turn on or turns
off suddenly, turn Power Switch to OFF
position, then check and reset the GFCI.
MIGLO6- Pressure Washer will run &87V while
Trigger is pressed. When trigger is released,
Pump will turn off. U&%8&$%7*,Z*%"97*%2&(%5&(*%
$.,8%&8*%5"8'$*%)"$.&'$%#/(,V"831
7. G*#$%#/(,V%,8%"84&8#/"4'&'#%,(*,:
a. Set Nozzle to low-impact fan spray.
b. Point Spray Gun at 45° angle to test area.
Release trigger safety lock, then press
Trigger. %S*%,),(*%&2%^"4^%+,4^1
c. Spray test area, adjusting pressure,
as needed, by changing distance from
surface and/or adjusting Nozzle.
d. If using detergent:
• Turn off unit, fill Detergent Tank,
then attach Black Nozzle.
• Turn on unit, then spray area with detergent
according to detergent manufacturer's
instructions. Scrub surface as necessary.
• Turn off unit, then switch to another Nozzle.
• Turn on unit, then spray area to rinse off
detergent, adjusting pressure as needed
by changing distance from surface and/
or changing to a different Nozzle.
e. Inspect test area for damage or discoloration.
To Next Page
Loading...