Page 8 For technical questions, please call 1-888-866-5797. 70595
Adjusting
Adjusting for Lathe Length
1. Measure the length of your Lathe from
the center of one mounting hole to the
center of the other mounting hole.
2. Loosen the two M10 x 20 Hex Bolts
on the Outer Beam. Slide the Beam
inward or outward to the desired
length, measuring from the slots in
the right mounting platform to the
slots in the left mounting platform.
3. Once the desired length has been
set, tighten the two M10 x 20 Hex Bolts
to secure the beams.
Leveling the Lathe Stand
1. Loosen the M12 Nut on the Base.
2. Adjust the leveling M12 x 100 Hex Bolt
and Foot to the desired height.
3. Tighten the M12 Nut against
the Base to lock in place.
Fastening Lathe to Stand
1. Securely mount your Lathe to the
Stand using fasteners (not included).
2. Fully tighten all fasteners.
To Next Page
Loading...