EN-5
TACKER SAFETY WARNINGS
1. Always assume that the tool contains fasteners.
Careless handling of the tacker can result in unexpected ring
of fasteners and personal injury.
2. Do not point the tool towards yourself or anyone
nearby. Unexpected triggering will discharge the fastener
causing an injury.
3. Do not actuate the tool unless the tool is placed
rmly against the workpiece. If the tool is not in contact
with the workpiece, the fastener may be deected away from
your target.
4. Disconnect the tool from the power source when
the fastener jams in the tool. While removing a jammed
fastener, the tacker may be accidentally activated if it is plugged
in.
5. Use caution while removing a jammed fastener.
The mechanism may be under compression and the fastener
may be forcefully discharged while attempting to free a jammed
condition.
6. When fastening electrical cables, make sure the
cables are not energized. Hold the tacker only by
insulated gripping surfaces. Use only fasteners designed for
electrical cable installations. Inspect that the fastener has not
damaged the insulation of the electrical cables. A fastener that
damages the insulation of electric cables can lead to electric
shock and re hazards.
7. Do not use this tacker for fastening electrical
cables. It is not designed for electric cable installation and
may damage the insulation of electric cables thereby causing
electric shock or re hazards.
To Next Page
Loading...