Bauknecht TRK 4821 - Electrical Connection; Electrical Safety and Requirements; Drainage System; Direct Drainage Setup

e The electrical connection has to be
carried out in compliance with local
regulations.
¢ Information on the voltage is given on the
rating plate on the back of the dryer.
¢ The earthing of this appliance is
compulsory by law.
e Do not use extension cords or multiple
adapters.
e Before any maintenance on the dryer,
disconnect it from the mains supply.
¢ Do not operate the dryer if it has been
damaged during transport. Contact a
qualified service technician.
Direct drainage at the rear of the dryer
To empty the water container directly into a sink
or a fixed drain:
(1) Remove the pipe in the lower part behind the
machine and mount it to the plastic connector
shown in diagram (put a rag underneath to
collect water spillage).
@) Connect the pipe supplied with the machine to
the connector. The maximum drain height is
Im.
3. Make sure that the pipe is not bent or twisted
(the end of the drain tube must not be
immersed in the drain water to avoid risk of
siphoning).
The hoses maximum length is 1,5 m.
17