USER INSTRUCTIONS
For safety reasons the oven door automatically locks at
temperatures above 300
°
C. When this occurs, the oven emits an
acoustic signal and the ‘lock’ indicator on the fascia panel becomes
illuminated.
During the pyrolitic function the oven light is disabled.
WARNING
·
All internal oven accessories must be removed before using
the pyrolitic function.
·
It is strongly recommended that the oven be only used in
pyrolitic mode with persons in attendance.
CLEANING THE APPLIANCE
Always allow the appliance to cool down before cleaning to avoid
a burn injury.
Do not use caustic or abrasive agents, coarse wire wool or hard
tools as these can damage the surface finishes.
Normally, wiping with a soft cloth dampened with hot detergent is
sufficient, but for stubborn marks the following is recommended:
VITREOUS ENAMEL PARTS
Use only a cleaner that is recommended for this type of material –
avoid chloride-based products such as bleach.
DOOR GLASS
Do not use any abrasive medium that could cause damage.
Remember that if the surface of the glass panel becomes scratched,
this could lead to a dangerous failure.
To facilitate cleaning, the door glass can be lifted out after
removing the fixing screws.
When refitting, make sure that the glass is correctly seated in the
door recess and the correct way round.
18
To Next Page
Loading...
