INSTALLATION INSTRUCTIONS
REPLACING THE MAINS LEAD
In the event it is necessary to replace the mains supply lead,
proceed as follows:
1.
Disconnect the appliance from the supply, undo the fixing
screws and remove the back panel.
2.
Undo the clamp screws and terminal screws to release the
existing lead.
3.
Assemble the replacement lead that must conform to the
specification listed in the Technical Data, ensuring the correct
colour code connection and that all screws are tightened
correctly.
MAINTENANCE
Before carrying out any maintenance, disconnect the ap pliance
from the electricity supply.
During the guarantee period, in case of need all service
interventions should be referred back to the Baumatic Ltd
Service department. Please note that intervention or repair by
any unauthorised personnel will invalidate such guarantee.
25
To Next Page
Loading...
