Baumatic BAF90EG - Page 15

Baumatic BAF90EG 900mm Upright Oven User Manual 15
Appliance Use and Maintenance
• To replace the oven bulb, just unscrew the protection cap that projects out inside the oven (Fig.16)
WARNING: Before replacing the bulb, disconnect the appliance from the electric power supply.
WARNING: The power cord supplied with the appliance is connected to the appliance with an X type connection (in
compliance with standards AS/NZS 60335-1, AS/NZS 60335-2-6 and subsequent amendments) for which it can be
installed without the use of special tools, with the same type of cord as the one installed.
• If the power cord becomes worn or damaged, replace it based on the information reported in table 2. To replace
the power cable, lift the terminal board’s cover and replace the cable.
CONTROL PANEL DESCRIPTION
• On the control panel, small symbols show the function of each knob or key. Here are the several controls that a
cooker can have:
Indicates which burner on the gas cooktop a control knob controls, a full square identifying the particular burner.
Indicates the control knob adjusts the functions of the electric oven.
shows the electric thermostat for electric fan oven.
shows the oven fan working button as to allow the oven to operates with fan assisted gas. The fan operation of
the oven prevents the operation of the grill, which therefore cannot be used with the fan in action.
Indicates the control knob adjusts the mechanical timer
shows the ignition key for the oven light (all except the electric fan oven)
shows the push-button for burner ignition
shows if keys are in position “on” or “off”
WARNING: If the power is cut off, the cook top burners can be lit with matches. When cooking foods with oil and fat,
which are very flammable, the user should not leave the appliance unattended. Do not use sprays near the appliance
when it is being used. When using the burners, make sure that the handles of the pots are correctly positioned. Keep
children away from the appliance.
Oven racks and trays
• The oven is supplied with a baking tray (with removable wire rack) and wire racks.
• Internally there is a wire support on either side with 5 mounting positions. The racks and tray are designed with a
small stop at the back. To insert, push the rack into one of the mounting positions angled down at the front so the
stop passes over the front of the support, and then push fully in. To remove, pull the rack out until the stop catches
at the front of the support & angle down to fully remove.