16 Baumatic BAF90EG 900mm Upright Oven User Manual
Using burners on cooktop
• A diagram is etched on the control panel above each knob which indicates which burner corresponds to that
knob. Each control knob controls a gas valve and built-in flame safety device.
• Manual lighting (it is always possible even when the power is cut off): Turn the control knob that corresponds to
the burner selected anticlockwise, setting it to the MAXIMUM position at the etched star (large flame on the control
knob (Fig. 18) and hold a lit match to the burner. Press the knob down and hold for 2 seconds after the burner
ignites so the thermocouple heats up. Release the control knob and adjust to the correct setting.
• Electric ignition: Turn the knob that corresponds to the burner selected anticlockwise, setting it to the MAXIMUM
position (large flame on the control knob (Fig. 18). Keep pressing the knob down at this position until the burner
ignites, and then wait 2 seconds for the thermocouple to heat up. Release the control knob and adjust to the
correct setting.
Appliance Use and Maintenance
Use of the dual burner (Fig19)
• This model controls both the central and external crown of the burner with just one valve.
• To ignite the central crown press and turn the knob to the maximum delivery position 1 and hold it down until
ignition: in this position the internal flame are at maximum.
• Turn the knob to position 2 to have the internal crown at the minimum.
• Turn the knob to position 3 to have the internal crown ant the external crown at the maximum.
• Turn the knob to position 4 to have the internal crown ant the external crown at the minimum.
Note: It is recommended not to try to ignite a burner if the relative flame cap is not in the correct position.
Tips for using burners correctly:
• Use suitably sized pots for each burner (see tab. 4 and Fig. 20).
Using the oven thermostat control knob
• The thermostat is used to set the maximum internal temperature of the oven. Turn the thermostat control knob
clockwise and align the selected temperature indicated on the knob with the index etched on the control panel
above it. Thermostat operation is indicated by an orange light which will turn off when the temperature inside
the oven is 10°C greater than the temperature setting, and will turn on when the oven is 10°C less than the
temperature setting. The thermostat can control the oven elements only if an oven function has been set. For
electronic timers, the timer must be off (“A” symbol off) or running.
To Next Page
Loading...
