o If the machine is situated on a carpeted floor, please adjust the
feet in order to allow air to circulate freely.
o There should be a gap of 2 cm either side of the condenser
dryer; a 10 cm gap should be left behind the appliance.
Power supply
o IMPORTANT: The electrical socket must still be accessible
once the appliance is installed.
o Consult the rating plate, located on the machine BEFORE
making the electrical connections. Ensure that the voltage
reaching the plug is the same as that on the rating plate.
o DO NOT REMOVE THE RATING PLATE AS THE
INFORMATION ON IT IS IMPORTANT.
o The moulded plug that is supplied with the appliance must be
placed into an earthed and insulated socket.
o Broken or damaged power leads must only be replaced by a
suitably qualified person. A power lead of a similar type must be
used in replacement.
o IMPORTANT: We do not recommend that this appliance is
connected to an extension lead.
Before first use maintenance cycle
o When your condenser dryer has been correctly installed, we
recommend that you perform a maintenance drying cycle, with only
clean rags being placed inside of the drum.
o This will check that all aspects of the installation are correct; it will
also remove any deposits that may have been left on the drum by
the manufacturing process.
o Select a QUICK drying programme.
21
To Next Page
Loading...
