20
Synthetic program
o Put the laundry into the drum and then close the door. The
maximum wash load size is 1.5 kg for the synthetic program.
o In the detergent drawer, put detergent into the main wash and
pre-wash compartments.
o Put detergent into the pre wash compartment only if you want to
use the pre-wash option.
o Softener should be poured into the middle compartment of the
detergent drawer; the level should be below the ‘MAX’ level.
o If you want to use bleach, then you should put it into the main
wash compartment with your detergent.
• Press the power button, the LCD display will show “---“ and all
the program lights will come on.
• Use the wash program selection knob to select the Synthetic
program.
• A wash temperature of 40°C, with an 800 rpm spin and 3 rinses
will be selected automatically by the appliance.
• You can use the TEMP button to adjust the wash temperature;
COLD, 30°C, 40°C and 60°C wash temperatures are available.
• You can use the SPIN button to adjust the spin speed. A 1400
rpm spin speed is not available with the Synthetic wash
program.
• You can use the OPTION button to select Pre-wash, Rinse+ and
Crease Care wash cycle options. Continue to press the OPTION
button until the wash cycle option or combination of options that
you want are lit on the LCD display.
* Press the Start/Pause button, the door will lock (confirmed by
the indicator on the LCD display) and after a few seconds you
will hear the machine start to fill with water.
To Next Page
Loading...
