16
i
rature rise of 85°C above the ambient
temperature of the room it is located in, during
depending on size) or 600 mm worktop that is at least 30
m thick. The following minimum clearance distances must be
o 700 mm between the hob surface and the underside of any
o 50 mm clearance around the front, back and sides of the
f a kitchen unit. There must
be a gap of at least 150 mm between the side of the hob and the
kitchen unit.
hen unpacking the appliance please check that the following items
hin the packaging:-
instruction manual
antee card
s
Fixing screws
Sealing strip
Position
ng
The adjacent furniture must be able to withstand a
minimum tempe
periods of use.
This appliance is classified as Class 3 and therefore is to be built into a
kitchen unit (
m
observed:-
horizontal surface above it.
appliance, measured from the cut out.
o If the hob is positioned so that the right or left hand side of the
appliance will be near to the edge o
vertical surface of the
Unpacking the appliance
W
are contained wit
1 Baumatic hob
1 Ceramic hob scraper
1 Installation and
1 Baumatic guar
4 Fixing bracket
4
1
To Next Page
