19
o The supplied brackets need
to be fitted to each of the
four corners on the
underside of the hob.
o Place a bracket onto each corner,
ensuring that the outer hole lines up
with the hole on the corner of the
hob.
o Fasten the bracket to the corner of
the hob with a screw.
o Place the long screw
into the fixing hole on
the outer edge of the
bracket but do not fully
tighten.
o Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o When the hob is correctly positioned,
tighten the long screws to fix the hob
securely in the aperture hole. These
screws MUST be securely
tightened.
To Next Page
Loading...
