Setting the clock
o When your appliance is connected to the power supply for the first
time, the LED display will show 00:00 and an audible signal will
sound once.
o Use the adjustment dial (8) to adjust the current time. You can
adjust the hour time between 00:00 – 23:59.
o When the display shows the correct time, release all buttons and in
a few seconds the time will be set.
IMPORTANT: If the clock is not set, the oven will not function.
IMPORTANT: IN ORDER TO CHANGE THE TIME AFTER IT HAS
BEEN INITIALLY SET, YOU MUST DISCONNECT THE OVEN FROM
THE POWER SUPPLY AND WAIT FOR 2 MINUTES BEFORE
RECONNECTING. THEN FOLLOW THE STEPS ABOVE.
Before first use
o To remove any residue from the oven that may have been left from
the manufacturing process, you should place a cup that is half filled
with water in the microwave.
o Set the microwave on its highest power level for 2 minutes.
o The oven cavity and outside of the appliance should be cleaned with
warm soapy water, using either a sponge or soft cloth. No abrasive
cleaners should be used. The appliance should be thoroughly dried
afterwards.
Microwave cooking
o Once the clock has been set, your microwave is then ready
to use.
o Check that the turntable and enamel tray are correctly assembled
in the cavity.
o Place whatever you are cooking in the centre of the microwave
cavity and then close the microwave door. IMPORTANT: You
should make sure that the door of the microwave is shut
securely.
o Press the ON / OFF button (4) once and the LED display will show
the default mode of 900W and a time of 01:00.
14
To Next Page
Loading...
