Installing your refrigerator
If you need the appliance door to open from the
other side, then please reverse the door before
commencing the installation process. (See Reversing
the door section).
4) Insert the top fixing bar
(a) into the slot on the top
of the appliance. Use the
Ø4.2 x 9.5 fixing screws (f)
to fit the fixing bar to the
top of the appliance.
o Pass the power
cable through to
the back of the
aperture. This will
allow the
appliance to be
easily plugged in,
once you have
completed the rest
of the installation.
18
e aperture.
ce door will open from.
are
installing it into.
o
hould slide the
appliance over to the far right of
the aperture.
5) Cut the sealing strip so that is the
same height as the height of th
o Stick the sealing strip onto the
side of the aperture that the
applian
o Carefully lift the appliance and
place it into the aperture of the
kitchen unit that you
Slide the appliance over to the far
left of the aperture, unless you
have reversed the door. In which
case you s
To Next Page
Loading...
