32
inimum flow adjustment for hob gas taps
All work must be carried out by a CORGI registered
engineer.
o Switch the burner
minimum
position.
from the tap and
place a small
bladed
screwdriver to
the outside the
o increase the gas flow
o
o ust be tightly
o
o that the flame does not go out by quickly turning
from maximum flow to minimum flow. If it does then remove
s
tment has been made.
M
on and set the
knob at the
o Remove the knob
tap.
Unscrew the adjusting screw, in order to
or tighten the adjusting screw to decrease the gas flow.
The correct adjustment is obtained when the flame has a
length of about 3 – 4 mm.
For butane/propane gas, the adjusting screw m
screwed in.
Refit the control knob.
Make sure
the control knob and make further adjustments to the ga
flow, testing it again once the adjus
To Next Page
Loading...
