EasyManua.ls Logo

Baumatic BT2760SS - Replacing the Mains Supply Cable

Baumatic BT2760SS
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
35
t
eplacing the mains supply cable
the mains supply cable is damaged, then it must be replaced by an
ap
Spa e
The m
following instructions:
o Open the box of the supply board.
o Unscrew the clamp (A) fixing the cable.
Replace the cable with one of the same length and in accordance
with the specification given above.
o The “green-yellow” ear minal
marked
o The cable can be looped if necessary, but make sure that is no
kinked or trapped when the cooker is in position.
R
If
propriate replacement which can be obtained from the Baumatic
r s Department.
ains supply cable should be replaced in accordance with the
o Switch the appliance off at the control switch.
o
th wire must be connected to the ter
. It must be about 10 mm longer than the live and
neutral wires.
o The “blue” neutral wire
marked with letter (N)
terminal marked with le
must be connected to the terminal
- the live wire must be connected to the
tter (L).

Table of Contents

Related product manuals