25
Attaching the glass canopy
o The anchoring bolts (F) should be found with the other brackets
and screws provided with the cooker hood. If you find them
already attached to the cooker hood, then you should unscrew
them.
o Carefully place the glass section (Q) on the upper surface of the
cooker hood and then slide it back towards the wall.
o Screw the anchoring bolts (F) through the relevant holes in the
glass section (Q).
o IMPORTANT: You must ensure that the glass section is securely
held in place by the anchoring bolts. However the anchoring
bolts must not be over tightened, otherwise excessive pressure
could be placed on the glass section.
To Next Page
Loading...
