Unpacking the appliance
When unpacking the appliance please check that the following items
are contained within the packaging:
1 x Baumatic hob
2 x Pan supports
4 x Burner assemblies
1 x Installation and instruction manual
1 x Baumatic guarantee card
4 x Fixing screws
4 x Clamps
1 x Sealing strip
4 x LPG jets
5 x LPG jets (P68SS only)
1 x Self-adhesive label for amending the Gas Category on the
appliance’s rating plate (required if the LPG conversion kit is used).
Installing the appliance
P61SS & P62SS P67SS & P68SS
o Cut a hole in the worktop that corresponds with the drawings
shown above.
o IMPORTANT: You must have a gap of at least 25 mm between
the underneath of the appliance and any surface that is below it.
To Next Page
Loading...
