This Track Dumper Is Not Suitable For:
•
Transport of people
•
Transport of overhanging cargo
•
Transport of liquids
Intended Use
The operator must be located, and must control the device carefully from, behind the
unit with hands on the controls during operation. The operator must wear proper
protective equipment such as hearing protection, safety helmet, safety goggles and
protective shoes. There should be no other people in the immediate vicinity of the
device, because of the risk of injury from moving parts and possibly from ejected
material. If the operator leaves the working position, the machine must be shut
down.
The machine may only be operated fully assembled in operation. If any parts are not
fully assembled or need replacing, e.g. Air filter, possibly battery cover, ... etc. and in
particular protective equipment such as belt guard, heat protection, exhaust or on/off
switch, the equipment must not be operated.
Operate the machine in such a way as to remove any overturning or risk of falling on
edges or embankments. The machine is to be guided such that the operator is not in
the direction of fall if an unforeseen tilting of the machine occurs.
When working on an incline, always take care not to exceed the maximum
admissible inclination stated in the technical data.
Transport
Always turn off the machine and allow the engine to cool before transporting the unit.
Prevent the unit from overturning, slipping or falling during transport with suitable
tested, lashing equipment. The lashing belts may only be fixed to the places
designated below:
To Next Page
Loading...