Lifting
Use only suitable and approved hoists, slings and lifting accessories with sufficient
capacity. Use only permissible lifting points according to the instruction manual and
ensure that the machine is secured reliably on the hoist. There must be no persons
in the immediate vicinity of the machine when lifting.
Storage
After operation, the cooled device should be protected from the weather and stored
out of the reach of children. For storage of more than one month, the fuel must be
drained during storage. For petrol engines, the carburettor must be emptied.
For damage caused by improper use, handling, disregard of
operating instructions, impermissible overspeed, deficient or
insufficient maintenance or separate structural changes carried out
without approval of the manufacturer, machine warranty, and the
liability of the manufacturer and the dealer, will be voided. The risk in
case of these events is solely with the operator.
Be sure to read the safety instructions and commissioning
instructions before starting the machine for the first time!
7. Before Starting
1.
Read the Safety section of the Operating Instructions!
2.
Check the engine oil level prior to each start-up!
3.
Make sure that the machine is clean, especially the cooling air inlet of the engine
and the air filter! If the air filter is dirty it must be replaced!
4.
Check all nuts and bolts are tight. Normal operating vibrations can loosen
screws/nuts/bolts and this can lead to serious accidents and/or damage to the
machine.
Check the Engine Oil
1.
Place the switched off machine on a flat, level surface.
2.
Remove dipstick and wipe.
3.
Replace the dipstick again, then remove it and read the oil level.
4.
If the oil level is low, add engine oil according to the "Technical Data” section!
Model RMD650 RMD650-B
Operating weight - Unladen (kg) c. 305 c. 300
Engine Loncin G270F Briggs & Stratton 900
Single-Cylinder 4-Stroke Petrol OHV
Rated capacity (kW) 6.6 not stated by B&S
Max permitted speed (rpm) 3600 3600
Engine oil content (l) 1.0 (SAE10W-40) 0.59 (SAE10W-30)
Spark plug E7RTC QC12YC
Electrode spacing (mm) 0.7 0.76
Fuel Unleaded Petrol (RON95) or Super E10
Tank capacity (l) 5.5 2.8
Max. permitted inclination 20º 20º
Gears 3 Forward, 1 Reverse
Engine starting Recoil Recoil
Skip tipping Hydraulic Hydraulic
Max. angle of tip 110º 110º
Skip dimensions (mm) 970x710x465 970x710x465
Track width (mm) 180 180
Dimensions LxWxH (mm) 1660x720x980 1660x720x980
Lash
Intake Valve (mm) 0.15 0.15
Outlet Valve (mm) 0.20 0.28
To Next Page
Loading...