10
FAILSAFE
For every single channel run through the system, no matter if stabilized or not, a failsafe value can be dened.
To use this option, set all transmitter channels to the desired values, followed by a click on the button ‚learn failsafe values‘. Done.
Note: The internal failsafe will only be activated, if there is no „proper“ signal received from the receiver (e.g. connection cut between
receiver and system). Thus, if there is a failure in the link between transmitter and receiver, and the receiver‘s failsafe is activated, the
system‘s failsafe will not activate.
To Next Page
Loading...
