Need help?Do you have a question about the BavarianDEMON AXON and is the answer not in the manual?
General| Brand | BavarianDEMON |
|---|---|
| Model | AXON |
| Category | Aircrafts |
| Language | English |
Highlights the system's capabilities, including optimal control, 3D capability, and torque control.
Details on mounting position, avoiding vibrations, heat, and using supplied mounting tape.
Instructions for transmitter setup, disabling mixers, and setting swash type.
Diagrams showing servo enumeration for different swash types for correct connection.
Guide for connecting servos and receiver using the standard cable loom.
Details on using serial output from receivers for a single-patch cable connection.
Instructions for connecting Spektrum satellite receivers for diversity.
Important notes on servo current, voltage supply, and BEC usage.
Explains LED signals during initialization and operation, including error indications.
Describes LED colors and patterns for Bank, Horizon, and Rescue modes.
Essential checks for neutral position, servo direction, and RC range before flight.
Guidance on backing up settings to a PC for safety and restoration.
Key points to observe during lift-off for optimal stabilization.
Explanation of how to use bank switching for different parameter sets via the head gyro channel.
Guidelines for setting tail gyro gain to prevent oscillations while maximizing holding force.
How to use Revo Mix to improve tail stability against torque changes.
Tips for improving tail response by addressing ESC performance.
Methods for optimizing rigid settings, gain, and agility for head stabilization.
Introduction to Horizon and Rescue modes, their purposes, and setup requirements.
Steps to activate and tune Horizon stabilization, recommending a switch for control.
Guidance on flying with self-leveling, including gain settings and potential oscillations.
Details on SCALE, ACRO, and UPRIGHT modes, including activation signals and LED indicators.
Overview of activating, deactivating, and configuring the internal governor via software.
Setting the waiting time parameter for proper RPM detection and governor activation.
Defining the spool-up time for gasser/nitro or electric motors for smooth RPM increase.
How to use and interpret the vibration analysis results for head, tail, and motor sections.
Solutions for common problems like servos not running, fine movements, and tail jerkiness.
Conditions that must be met for processing warranty claims, including purchase receipt.
Information on how to contact for service, authorized dealers, and general inquiries.
To Next Page