VIBRATION ANALYSIS
This page shows the result of the vibration analysis, divided into head, tail and motor sections.
If all sections are green, no critical vibration has been detected.
If critical vibration is detected, the section with the highest vibration will be marked rst.
Example:
Tail and head have too high a level of vibration, but the tail is worse. In this case tail would be marked rst (yellow or red, depending on the
strength of the vibration). Once this issue is solved, in the next step the head would be marked. Once all issues are solved, this will be shown
by all sections marked green.
This is how to use this feature: the heli must be own for 30-60 seconds. It is sufcient to hover or do slow ying. Then connect the system to
the software, open the vibration analysis and see the result, as explained above.
Important:
Do check the vibration analysis in the software prior to the next lift-off, as data will be overwritten with the new ight‘s data at this time.
17
To Next Page
Loading...