Baylan TM-A - Warning and Attention; Warning; Attention

2
Warning and Attention
Warning
 Don’t use scales in the following situations:
1. Wobbling and swaying place;
2. Air-conditional and fan blowing straight place;
3. Dusty and wet environment;
4. Flammability and explosive place;
 Plug the power switch to the good grounded socket, or it will cause personal injury.
 Ensure to cut the power off first when the scale is connected to other equipment, or it will cause the
equipment damaged.
 Don’t plug in or pull out each communication interface with power on, such as RS232 COM port, etc.
 Don’t plug in or pull out switch when the power is on.
 This type of scale uses thermal printer, so only thermal printing paper can be used. Please use correct
type of paper before print, or it will cause the irreparable damage to the printer head and printer.
Attention
 Put the scale on a level table-board. Adjust four corner nuts to make the level bubble be in the middle
of gradienter. Try to make sure the sensor work in level status and keep accuracy of weighing.
 If printer goes wrong or shows wrong, even gives warning without printing, that mean the scale has got
problems. You’d better check the paper whether put correctly or the printer head is in the correct
position, or the light sensor is dirty. If it is dirty, clear the printer head and the printer for every two
weeks. Keep the print paper clean and good quality.
 After changing the paper, the printer buttons are found to be no effective or print wrong. It probably
caused by the type of the paper not being the same size. The problem can be solved by re-debugging,
putting paper again and making paper checkout.
 Please don’t dismantle, break or impact the scale.