Do you have a question about the Bayliner 225 and is the answer not in the manual?
Details dimensions and tank capacities for 185, 195, 205, and 225 models.
Guidance on dealer service and obtaining warranty information.
Advice for new operators and information on engine/accessory literature.
Maintenance advice including structural limits and moored boat care.
General safety standards and hazard warnings for boat operation.
Information on CO hazards, facts, symptoms, and prevention measures.
Specific warning labels applicable to the Bayliner 185 model.
Specific warning labels applicable to the Bayliner 195 model.
Specific warning labels applicable to the Bayliner 205 model.
Specific warning labels applicable to the Bayliner 225 model.
Diagrams showing exterior views of the boat.
Diagrams of hull views for 185 and 195 models.
Diagrams of hull views for 205 and 225 models.
Diagrams showing deck layout for the 185 model.
Diagrams showing deck layout for the 195 model.
Diagrams showing deck layout for the 205 model.
Diagrams showing deck layout for the 225 model.
Typical helm layout for 185, 195, and 225 models.
Typical helm layout for the 205 model.
Locations of 12-volt DC accessory outlets.
Location of the 12-volt DC fuse block.
Locations of boat batteries for various models.
Locations of bilge pump and helm blower switch.
Locations of depth finder transducer and freshwater fill fitting.
Location of freshwater pump and switch for the 225 model.
Location of the freshwater tank on the starboard side of the engine compartment.
Location of the fuel fill deck fitting for GAS or DIESEL models.
Locations of fuel shut-off valve and fuel tank.
Locations of livewell system parts like aerator, pump, and switch.
Identification of bow and stern navigation lights.
Locations of transom shower (225) and trim/tilt pump.
Locations of trolling motor, DC circuit breaker, and receptacle.
Guidance on engine operation, maintenance, and related literature.
Operation and safety of the bilge blower system for fume removal.
Information on the boat's fuel system, including hazards and routing.
Details on fueling procedures and tank venting.
Maintenance and replacement of fuel filters.
Function and troubleshooting of the anti-siphon valve.
Maintenance and inspection of the fuel filter/water separator for diesel engines.
Installation and use of the quick oil drain system for engine oil changes.
Information on the power-assisted rack-and-pinion steering system.
Safety warnings and guidance for shift/throttle control maintenance.
Information on the stern drive's power trim and tilt system.
Details on gauge cleaning, fogging, radio interference, and fuel gauge behavior.
Warnings and guidelines for using the depth finder as an aid.
Operation and safety of the bilge pump and autofloat switch.
Procedure for testing the bilge pump and checking for clogs.
Operation and testing of the autofloat switch for the bilge pump.
Information on seawater systems, seacocks, and strainers.
Filling, draining, and aeration of the livewell system.
Operation, maintenance, and winterization of the freshwater system.
Instructions for using the transom shower.
Steps for winterizing the freshwater system using compressed air or gravity.
Function and care of deck drains for overboard water removal.
Warnings about using cleats and bow/stern eyes for lifting.
Instructions for using the bow mount trolling motor.
Safety guidelines and proper use of the ski-tow ring.
Safety, attachment, and folding instructions for the ski-tow tower.
Step-by-step guide for folding and unfolding the ski-tow tower.
Care, cleaning, and stain removal for boat canvas.
Proper care and cleaning for clear vinyl windows.
Installation instructions for the 185 model Bimini top.
Installation instructions for the 205 and 225 model Bimini tops.
Installation and adjustment of the convertible top.
Installation of side curtains for 205 and 225 models.
Installation instructions for the bow cover.
Information and notices regarding the boat's audio equipment.
Operation and conversion of sleeper seats into lounge positions.
Procedure to convert jump seats into a sunlounge.
Procedure to convert passenger seat to sunlounge for 225 model.
Instructions for installing, removing, and stowing the table leg.
General care and maintenance for boat lights.
Information on interior and exterior lights and battery usage.
Guidelines for using navigation lights and avoiding obstruction.
Critical safety warnings for electrical system work and fuel compartments.
Warnings about fuel vapors and electrical devices before starting.
Caution against disconnecting battery cables while the engine is running.
Tips for reducing corrosion on electrical connections.
Overview of the 12-volt DC system, including battery and fuses.
Usage and protection of 12-volt DC accessory outlets.
Function of the alternator in charging the battery.
Diagrams showing electrical wiring routings throughout the boat.
Diagram of the 12-volt DC hull harness routing.
Diagram of the 12-volt DC deck harness for 185 and 195 models.
Diagram of the 12-volt DC deck harness for the 205 model.
Diagram of the 12-volt DC deck harness for the 225 model.
Wiring diagram for the trolling motor harness.
Diagram showing battery cable connections and color coding.
Section for recording selling dealer contact information.
Section for recording key numbers like ignition.
Section for recording electronics manufacturer, model, and serial numbers.
Section for recording engine manufacturer, model, serial, and oil details.
Section for recording propeller manufacturer, model, and pitch.
Section for detailing the boat's specifications and registration.
Section for recording operator's personal and experience details.
Section for listing names, ages, and health of persons on board.
Section for planning trip details, routes, and expected arrival times.
Section for recording details of the vehicle used for transport.











