5
Connect to the Internet
Now that you have the thermostat in and working, it is time to connect it to the Internet to
enable it's advanced capabilities.
A) Connect the Control Module to the Internet. Plug one end of an Ethernet cable into the
LAN port on the bottom of the Control Module and the other end into a port on a router
or switch on your home network.
B) If direct wiring is not convenient, use Power line Ethernet adapters. Plug one adapter
into a power plug near the control module, and the other adapter near your home
router. Then just plug the Ethernet cables into the adapters and the ports.
13
To Next Page
Loading...