Bazooka ELA1190 - Page 4

SRFETY PRECRUTIONS
Fuse amplifiers power wire at the battery.
Be sure to fuse the power wire within 12" of the car's battery. This will protect the car's
battery in case of a short circuit between the powep amplifier and battery. THIS IS R MUST,
the amplifier's built-in fuse will only protect the power amplifier not the car's battery!
Use highgrade wire connectors.
To ensure maximum power transfer and secure safe connections, it is recommended to
use high grade barrier spades (for connection at amplifier if applicable) and terminal rings
(for connection at battery).
Do not run any wires underneath vehicle.
Exposed wires have a chance of being cut or damaged. It is best to run all wires through
the vehicle under the
carpet and/or side panels. This lends to a cleaner installation and
less risk of damage.
Use caution whenmounting amplifier.
Remember there are many electrical wires, gas lines, vacuum lines, brake lines as well as a
gas
tank in the automobile. Make sure you know where they are when mounting the
amplifier to avoid puncturing lines, shorting wires or drilling holes in thE gas tank.
Run signal wires away from electrical wires.
To avoid possibility of inducEd noise from thE car's electrical system (Le. popping noises or
enginE noise), run wires away from the car's electrical wiring.
Make all ground wires as short as possibleand at the same point
In order to reduce the chance of ground loops (Le. engine noise), make the grounding wire
as short as possible to reduce the wire's resistance. Rlso, when using multiple
components, make
sure all units are grounded at the same point.
Rvoid sharp edges whenrunning the wires.
To avoid the possibility of power, signal or speaker shorts, be careful not to allow thE
amplifiers wires to come in contact with sharp edges. Use a grommet to protect the wire
whEn running through the firE wall.
3