BBE 822 - Page 7

Specifications BBE 822
Frequency Response
Bypass
Process Mode
Noise in Process Mode
Total Harmonic Distortion
in Process Mode
Input Characteristics
Input Impedance
Nominal Input Range
Maximum Input Level
Output Characteristics
Minimum Load Impedance
for Full Output
Nomimal Output Level
Maximum Output Level
Output Impedance
Power Requirements
120VAC (nominal) 50/60Hz
A/C Line fused protected
Terminations/Connectors
Rear Panel
Dimensions
1 3 / 4 " H X 17" W X 7" D
DC to 20kHz
program controlled
-85dBu below OdBu output level
less than 0.1% @ 1kHz @ +4dBu
10K Ohms (balanced or unbalanced)
-lOdBu to +8dBu
+ 24dBu (input clip point)
600 Ohms (balanced or unbalanced)
-lOdBu to +8dBu
+ 24dBu into 600 Ohm Load (clip point)
680 Ohms (balanced or unbalanced)
8 watts
XLR and 74" Tip-Ring-Sleeve (Tip is hot)
Standard lU single rack
Weight
6 lbs.
NOTE: OdBu = 0.77rVrms
ALL SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE