Flip the vehicle over and lay it on a level surface.
Slide on a part 1 washer, part B wheel, and another part 1 washer onto a front wheel axle and secure it
with a part 3 pin. Repeat on the other side. Snap a part C hub cap onto each wheel.
Slide the part A rear axle through the body of the vehicle.
Insert a part D gear box into one side of the axle. Route the wires from the gear box through the body
of the vehicle and into the seat. Slide on a part 2 metal spacer, part B wheel, and part 1 washer onto
the rear axle and secure it with a part 3 pin. Repeat on the other side. Snap a part C hub cap onto
each wheel.
Pg. 5
1
2
B
B B
B
C
C
2
2
1
1
3
1
1
3
1
3
1
3
D
D
C C
A
PRODUCT ASSEMBLY
To Next Page
Loading...
