EasyManua.ls Logo

BCP SKY2071 - Maintenance and Troubleshooting; Charging Instructions; Care and Maintenance; Troubleshooting Guide

BCP SKY2071
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHARGING INSTRUCTIONS AND WARNINGS
CARE AND MAINTENANCE
Charging socket is located on the back of the vehicle near the rear left wheel. Insert one end of the
part F charger into the charging socket and plug the other end into a wall outlet.
Charge the battery at least 18 hours before initial use.
On average, you will need to charge the battery between 8 and 12 hours. Do not charge the battery
for more than 20 hours. Failure to charge the battery as directed could cause permanent damage
to the battery and void the warranty.
Damage to the battery may occur if it is allowed to drain completely. Do not allow the battery to
drain completely.
Check the battery and charger (supply cord, connector) for wear and damage before charging.
Do not charge the battery if damage has occurred.
Only an adult who has read and understood the safety warnings should handle, charge and
recharge the battery.
Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
Do not leave the vehicle in the sun for long periods of time or fading may occur. Store in shade or
cover with tarp.
Do not wash the vehicle with a hose.
Do not wash the vehicle with soap.
TROUBLESHOOTING
Reason
Low battery
Electrical protection
Switch not in the correct position
Battery connectors disconnected
Low battery
Overloaded vehicle
Uneven or sloped road
Loose connection to motor
Battery connectors disconnected
Charger not connected to socket
or outlet
Battery does not have a full charge
Normal
Problem
Battery is warm and
makes a slight noise while
charging
Slow speed
Vehicles shakes while
driving
Battery does not last
Battery does not recharge
Vehicle does not move
Solution
Fully charge the battery
Stop use for several minutes and restart
Completely press in switches
Plug in battery connectors
Fully charge the battery
Reduce the weight on the vehicle
Drive on flat pavement
Ensure the motor is properly connected to
the battery
Gear boxes are installed
incorrectly
Forward and reverse
switch is flipped (forward
goes in reverse, reverse
goes forward)
Make sure the L gear box is on the left and
R gear box is on the right
Plug in battery connectors
Completely plug in the charger
Fully charge the battery
Normal
Pg. 7

Related product manuals