STORAGE
• Keep unit upright during transportation or storage. Do not move unit on its side.
• For prolonged storage, do the following:
- Drain all water from tank
- Run fan mode for half a day to dry the interior
- Clean air filter and remove exhaust hose
- Cover appliance
- Store in a cool, dry place away from direct sunlight and dirt.
10 |
TROUBLESHOOTING
PROBLEM REASON SOLUTION
Does not turn on
Not working when turned on
Excessive noise
Not cool enough
Make sure unit plugged in
properly
Replace remote batteries
Drain water
Adjust temperature
Water tank full
Not plugged in
Overheat feature activated
Remote has low battery
Room temperature lower than
set temperature (cool mode)
Exhaust hose not attached or
blocked
Connect or clean exhaust hose
Temperature set too high
Uneven ground
Set unit on a flat, stable surface
Adjust temperature
Clean air inlet
Air inlet blocked
Heat sources in room
Remove heat sources
Close doors/windows
Doors/windows open
WF indicator on, water tank full
Allow unit to cool for 3 minutes
then try again
Drain water
E2 error code
To Next Page
Loading...