BCP SKY4726 - Operating Instructions; Cooling and Dehumidifying Modes; Fan Mode and Timer; Maintenance Procedures

OPERATING INSTRUCTIONS
DRAINING WATER
CLEANING
Cooling:
1. Press Mode button until cool indicator turns on.
2. Adjust to desired room temperature (62°F-88°F).
3. Press Speed button to select desired fan speed.
Dehumidifying:
1. Press Mode button until dehumidify indicator turns on.
2. Adjust to 2 degrees below room temperature.
3. Press Speed button and set fan speed to low.
4. When the WF (water full) indicator turns on, drain water through the drain outlet.
Fan:
1. Press Mode button until fan indicator turns on.
2. Press Speed button to select desired fan speed.
NOTE: Exhaust hose not required in fan mode.
Timer:
Set timer auto-start:
1. With the air conditioner turned o, press the Timer button.
2. Set the temperature and desired timer start time within 0 to 24 hours from now.
When the WF (water full) indicator turns on, the internal water tank must be drained.
1. Remove the rubber cap and stopper from the drain outlet.
2. Drain water into an appropriate vessel or outside.
| 9
• Turn o and unplug the appliance before cleaning or storage. Allow unit to cool completely.
• It is very common for dust to gather in the inlet/outlet and cause overheating. Routinely clean the
housing and openings with a slightly damp cloth, vacuum cleaner, or dusting brush.
• Do not clean with gasoline, benzine, thinner, or harsh cleaners.
• Clean air filter as necessary:
- Slide out the removable air filter.
- Clean air filter with mild detergent and lukewarm water.
- Allow air filter to completely dry and replace.
Set timer auto-stop:
1. With the air conditioner turned on, press the Timer button.
2. Set the temperature and desired timer end time within 0 to 24 hours from now.