8 |
PRODUCT ASSEMBLY
4
5
Remove two nuts and washers from the front axle.
NOTE: Leave two washers on the axle, one on each side.
Slide a part A wheel onto the front axle, then secure it by replacing a nut and washer. Snap on a
part B hubcap. Repeat on the other side.
Slide a part A wheel onto the rear axle, then secure it by replacing a nut and washer. Snap on a
part B hubcap. Repeat on the other side.
NOTE: Use two plastic wrenches (one on each side) and rotate in opposite directions to tighten nuts.
A
x2
A
x2
B
x2
B
x2
To Next Page
Loading...
