27
4e. It should be placed in the right position, this means
that the harness should come out approximately 1 cm
above the child’s shoulders 4f. Close the compartment
again.
4g. Once the child is positioned correctly, tighten the
harness by pulling the strap making sure that it ts
snugly.
The correct tension means that between the harness
strap and the baby’s chest there should be a gap of
no more than 1 cm. (just enough to slide one nger
between the baby and the harness).
Getting the child out of the safety seat.
4h. Loosen the harness straps by pressing the tension
button. Then unfasten the buckle and lift the child
out 4a.
WARNING! The straps must not be twisted. The harness
must be correctly fastened and the straps should t
the child snugly.
5. FITTING THE SEAT ONTO THE PRAM
5a. With the handle set to position 4 (diagram 2e), slot
the baby carrier onto the pram anchors until you hear
it click into place.
5b. To detach the baby carrier from the pram, press the
prox button (10) and pull the baby carrier upwards.
MAINTENANCE
Removing / Fitting the cove
The cover of the NADÓ seat is very easy to take off. On
the front part there are 2 fastening points for the cover.
Unfasten these two points and gently pull the front part
of the cover.
On the sides of the seat there are some plastic parts
designed to hold the cover in place. Simply pull the
cover over them gently to take it off.
To t the cover back on again, follow the same steps in
reverse. Place the parts in the slot for the sides.
IM 2041,02 ONE instruc ok.indd 27 3/5/21 14:10
To Next Page
Loading...