Be Cool Sun - Car Seat Installation; Installation for 40-105 CM

EN
50
1. INSTALLATION FOR 40-105 CM
Forward facing ISOFIX + top tether + harness
1. Pull the central adjuster to recline the seat
2. The whole seat can be turned round
3. Pull the central adjust to rotate the seat
4. Turn the safety seat to place it in the rear facing
position. Adjust the position of the backrest to the
rear facing position.
Read carefully the section referring to the Isox
anchor points in the vehicle instructions (bear in
mind that not all vehicle seats may have Isox
anchor points. The restraint system may not be
used without the device)
5. Connect the Isox guide to the device (optional)
6. Extend the two sides of the Isox as far as they
will go
7. Hold the safety seat and connect the Isox base to
the device
8. You will hear it click when correctly inserted
9. Check that the indicator has the same number and
displays the green signal. If the indicator displays
the red signal, try the procedure again.
10. Push the safety seat until it is in rm contact with
the vehicle seat.
11. Pull the safety seat to check that the Isox system
is locked
12. Check that the Isox anchor is correctly connected.
12A. Location of the anchors for the Top Tether
A. Cover found behind the rear seats (most vehicles)
B. Luggage storage area found on the oor and
behind the rear seats
C. Underneath the seat (in very few vehicles)
D. Behind the backrest of the seat
IM 2291,00 SUN INST 2.indd 50 23/6/21 7:51