Be Cool Sun - Installation for 76-105 CM

EN
52
NOTICE: Seat padding. Padded waist support.
- For a child with a height of 40-75 cm the seat
padding and the padded waist support will both
need to be used.
- For a child with a height of 76-80 cm only the seat
padding will be necessary.
2. INSTALLATION FOR 76-105 CM
Forward facing ISOFIX + top tether + harness
Read carefully the section referring to the Isox
anchor points in the vehicle instructions (bear in
mind that not all vehicle seats may have Isox
anchor points.
The restraint system may not be used without the
device)
1. Connect the Isox guide to the device (optional)
2. Extend the two sides of the Isox as far as they
will go
3. Hold the safety seat and connect the Isox base to
the device
4. You will hear it click when correctly inserted
5. Check that the indicator has the same number.
Adjust the backrest to position 1, 2, 3 or 4.
If the indicator displays the red signal, try the
procedure again.
6. Push the safety seat until it is in rm contact with
the vehicle seat.
7. Pull the safety seat to check that the Isox system
is locked
8. Check that the Isox anchor is correctly connected.
8A. Location of the anchors for the Top Tether
A. Cover found behind the rear seats (most vehicles)
B. Luggage storage area found on the oor and
behind the rear seats
C. Underneath the seat (in very few vehicles)
D. Behind the backrest of the seat
IM 2291,00 SUN INST 2.indd 52 23/6/21 7:51