Need help?Do you have a question about the BE QUIET! PURE POWER 12 M and is the answer not in the manual?
Steps for safely removing the old power supply unit from the PC.
Instructions for installing the new power supply unit into the PC case.
Protects against excessive current by automatically shutting off the power supply.
Protects against low voltage by automatically shutting off the power supply.
Protects against high voltage by deactivating the power supply.
Prevents physical defects from short circuits in the power supply and connected components.
Shuts down the power supply if it overheats to prevent damage.
Shuts off the power supply if the total output exceeds the maximum specified load.
Explains that BIOS/UEFI voltage readings may be inaccurate and not indicate a real problem.
Addresses issues where the PC fails to boot or crashes after installing a new graphics card.
Defines who the warranty applies to and proof of purchase requirements.
Outlines the duration of warranty coverage for parts and labor.
Lists conditions and damages not covered by the warranty.
Specifies damages that be quiet! is not liable for under the warranty.
States limitations on implied warranties like merchantability or fitness for a purpose.
Mentions consumer rights granted by local law which may vary.
Clarifies that no other warranties or modifications are authorized.
Displays the product label information including AC input and DC output specifications.
Details the voltage tolerance and ripple/noise limits for each DC output.
Specifies the recommended temperature and humidity ranges for operation and storage.
Shows the minimal load requirements for each DC output rail.
Illustrates the power supply's rail distribution and connector layout.
Provides the physical dimensions (L x W x H) of the power supply unit.
Details the types of connectors and the lengths of the supplied cables.
General| Efficiency | 92.6 % |
|---|---|
| Total power | 750 W |
| Power factor | 0.98 |
| Input current | 10/5 A |
| AC input voltage | 100 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Combined power (-12V) | 3.6 W |
| Combined power (+3.3V) | 120 W |
| Combined power (+5Vsb) | 15 W |
| Max output current (-12V) | 0.3 A |
| Power protection features | Over current, Over power, Over voltage, Overheating, Short circuit |
| Max output current (+12V1) | 36 A |
| Max output current (+12V2) | 32 A |
| Max output current (+3.3V) | 20 A |
| Max output current (+5Vsb) | 3 A |
| Power Good signal delay range | 100 - 150 ms |
| Power Factor Correction (PFC) type | Active |
| Fan diameter | 120 mm |
| Fan location | Top |
| On/off switch | Yes |
| Product color | Black |
| Number of fans | 1 fan(s) |
| Operating temperature (T-T) | 0 - 40 °C |
| Cabling type | Fully-Modular |
| SATA power cable length | 500, 650, 800, 950 mm |
| Motherboard power connector | 20+4 pin ATX |
| Motherboard power cable length | 550 mm |
| Number of PATA power connectors | 2 |
| Number of SATA power connectors | 5 |
| Peripheral (Molex) power connectors (4-pin) | 1 |
| Purpose | PC |
| ATX version | 3.0 |
| EPS version | 2.92 |
| Noise level | 24 dB |
| 80 PLUS certification | 80 PLUS Gold |
| Mean time between failures (MTBF) | 100000 h |
| Power supply unit (PSU) form factor | ATX |
| Noise level (quiet mode, 50%) | 8.9 dB |
| Noise level (silent mode, \u003C30%) | 8.4 dB |
| Warranty period | 10 year(s) |
| Sustainability certificates | ENERGY STAR, ErP, RoHS |
| Cables included | PATA, PCIe, Peripheral (Molex), SATA |
Weight and Dimensions| Depth | 150 mm |
|---|---|
| Width | 160 mm |
| Height | 86 mm |
To Next Page