Be-Tech 3001D Series - Error List Introduction

SMART SAFE 3001D-1HL/3HL/5HL
SMART SAFE 3001D 1HL/3HL/5HL
11-11
NOTICE
If the power supply cable is damaged for any reason whatsoever, disconnect it from the power supply system
– or take the plug out of the socket – and get in touch with our Sales Service.
ERROR LIST INTRODUCTION
Err0
Inputted code less than 4 digit or more than 9 digit.
Incorrect Code
Err2
Latch bolt didn’t reach to corresponding places.
P_Lo
Battery low voltage
HOLd
Keypad locked down
OPEn
Success to open
CLSd
Success to close
PrOG
Entered into programming mode
1St
Please input code once
2nd
Please input code again
dEL*
Delete service code (* digit will display 1 to 5, corresponding
service code group 1 to group 5)
dEL ALL
Delete all service code
_
Processing bar, will moving when closing and opening
Id_*
Please input your own code (* will display 0 to 5, Id_0
corresponding Owner Code, Id_1~Id_5 corresponding service
code group 1 to group 5)
dOnE
Setup success