Need help?Do you have a question about the BE AM Series and is the answer not in the manual?
Emphasizes reading the manual before use for efficiency and cost savings.
Advise on consulting dealer for doubts and using genuine parts.
Explains WARNING, CAUTION, and Note terminology used in the manual.
Lists potential hazards like thrown debris, PTO entanglement, and hydraulic injection.
Outlines essential checks and preparations before operating the machine.
Steps for site preparation, machine lifting, and aligning gearbox/PTO shafts.
Details on axle plate installation and catch assembly mounting.
Steps for connecting linkages and safety warnings for control operation.
Connecting lower linkages and fitting the stabilizer nose.
Maneuvering for flail head attachment with correct bracket alignment.
Emphasizes reading instructions and following the exact order for safe removal.
Detailed steps for safe tractor removal.
Advises on greasing parts and covering during outdoor storage.
Operator guard importance and practicing controls without rotor engagement.
Identifies symbols for Angle, Lift, Reach, Slew, and Rotor Control levers.
Explains how breakaway works, including 'Auto Reset' and manual 'Slew' reset.
Instructions for switching off rotor, lift, float, and slew engagement.
Advises on PTO disengagement, power off, and speed to avoid bouncing.
Specifies operating speeds and warns against exceeding them.
Mandates 1.5m clearance near high voltage cables.
Describes the order of cutting: field side, road side, then top.
Details daily greasing points.
Instructions for checking oil level and identifying contamination.
Exploded view diagram of the control assembly.
Exploded view of mowing part components.
Exploded view of fuel tank assembly.
Exploded view of linkage assembly.
Exploded view of hydraulic manifold.
Exploded view of gear housing assembly.
To Next Page
General