What to do if my BE Commercial Pressure Washer system will not start?
If your BE Pressure Washer system won't start, ensure that power is applied and the water supply is turned on. You may also need to check the water supply, referring to the WATER SUPPLY section for guidance.
How to fix a BE Commercial when the pump runs extremely rough?
If your BE Pressure Washer pump runs extremely rough, make sure the inlet plumbing is the correct size and has an airtight seal. Also, purge any air from the system.
What to do if my BE Commercial has low pressure?
If your BE Pressure Washer has low pressure, replace the nozzle with the correct size. Tighten or replace the belt, ensuring it's the correct type. Disassemble the plumbing. Clean and adjust the unloader valve, checking for a worn or dirty valve seat. Clean the filter, using an adequately sized one, and check it more frequently. Clean or install the proper inlet filter, and ensure adequate inlet water pressure. Clean and/or replace valve assemblies. Finally, replace or repair the discharge hose.
Why does my BE Pressure Washer start but run rough?
If your BE Pressure Washer system starts but runs roughly, check the water supply referring to the WATER SUPPLY section. You should also check the condition of components and clean or replace them as needed. Inspect for any cracks or breaks in the system.
Explains safety alert symbols and their associated hazard levels for safe operation.
Guidelines for selecting an appropriate operating location and preparing the system.
Critical information on water source quality, pressure, and connection methods.
Recommendations and precautions for using natural water sources and inlet filters.
Essential electrical safety, grounding, and compliance with codes for installation.
Essential checks before starting and the purpose of surge arrestors.
Guidelines for system pressure adjustment and selecting the correct high-pressure nozzles.
Steps to protect the pressure washer from damage due to freezing temperatures.
Recommended daily, monthly, and annual maintenance procedures and intervals.
Steps for installing the system and filling the heat exchanger tank.
Safe operation of the unit and factory-set pressure regulation guidelines.
Overview of the comprehensive warranty coverage provided for BE pressure washers.
Details on warranty periods for frame, motor, pumps, coil, burner, and accessories.
General| PSI | 4000 |
|---|---|
| GPM | 4.0 |
| Power Source | Gasoline |
| Hose Length | 50 Feet |
| Frame | Steel |
To Next Page
