10
LUBRICATION AND MAINTENANCE
1. Every 5 hours of work the nipples and the inner tube of the P.T.O. shaft must be greased.
2. Every 10 hours of work the 2 nipples on the gearboxes must be greased.
3. Every 10 hours of work the 2 nipples in the wheels must be greased.
At the end of the season, the machine must be cleaned and made ready for the following season.
INSTRUCTIONS FOR ORDERING SPARE PARTS
Your order for spare parts should contain the following information:
1. Machine-type and frame number.
2. Description, part number, and quantity of parts in question.
If in doubt, send a rough sketch or pattern clearly marked with your name and address.
Only original PZ spars ensure excellent quality and correct fitting.
ACCESSORIES
When using tractors, the lift capacity of which is insufficient, it may occur that the Haybob cannot be
raised high enough in some cases. In order to improve this, the following set can be fitted (see fig.10.)
: fig. 10
Attention: The bolts and nuts must be tightened firmly and this has to be checked
after some hours of work.
1X TH – 142 Spacer
2X ND – 1113 Bolt M12X40
2X ND – 2015 Snep nut M12 H130
The part number of this set reads TH - 00142
To Next Page
Loading...