4
19. Always adapt the speed to the local conditions! When making short turns note the larger radius because of increased
width and/or length of the combination as well as mass and inertia changes due to the other center of gravity
position!
20. No one should operate the machine unless all protection is installed and in functional position!
21. Never stay or allow anyone to stay within the operating area!
22. Never stay or allow anyone to stay within the turning and slewing area!
23. Before leaving the tractor, lower the machine onto the ground, apply the parking break, shut down the engine and
remove the ignition key!
24. Allow nobody to stay between tractor and machine unless the tractor is prevented from inadvertent rolling away by
applied parking brake and/or placed chocks!
4.1.4 Storage Safety
53. Store the unit in an area away from human activity.
54. Do not permit children to play on or around the stored unit.
55. Use the provided jack stand supports, store in stable machine mode.
4.2 LIABILITY AND WARRANTY
In order to ensure safety, all persons working at and/or with this machine must read and understand this operation
manual. Furthermore, this machine shall always be used, handled and stored in accordance with the design and
construction destination (intended use) which also means:
1. Exclusively work in accordance with the instructions given in the appropriate Assembly, Operation and Repair
Instructions (manual) including all valid Errata and Supplements as well as taking into account the relevant
Service Bulletins; exclusively use correct tools and equipment being in a perfect condition.
2. Strictly observe the applicable local regulations concerning safety and accident prevention, generally
acknowledged and approved technical, medical, and traffic rules as well as the functional limitations and safety
instructions stated in above mentioned technical documentation!
3. Do not use any parts (spares, accessories, lubricants) other than those complying with manufacturer
requirements. A part complies with manufacturer requirement when either genuine or approved by the
manufacturer or when all its properties can be proven to meet with the appropriate manufacturer requirements
for that very use/function!
4. Only well instructed people being familiar with all possible danger shall work with or at the machine!
5. The machine shall not be used nor transported unless all safety devices (covers, plates, rails, curtains, locks,
etc.) are correctly installed and in a perfect condition and set in the appropriate safety position! All safety decals
and signs shall be legible and in the correct place!
6. Unauthorized modification of or arbitrary changes on the machine or parts of it exclude any responsibility and
reliability of the machine manufacturer for the consequences of that operation!
Attention: Those disregarding above mentioned rules act grossly negligent (careless) through which all
manufacturers warranty and reliability for damages and all other consequences become extinct.
The negligent person carries all risks!
To Next Page
Loading...
