BEA 71/16-421 - Flammable Substance Hazard; Correct Fitting Requirement; Trigger Safety; Discharge Outlet Safety

Wire Sta
p
ler 71/16-421
4. DO NOT OPERATE THE TOOL NEAR A FLAMMABLE SUBSTANCE.
Never o
p
erate the tool near a flammable substance
(
e.
g
.
,
thinner
,
g
asoline
,
etc
)
. Volatile fumes from these substances could be
drawn into the compressor and compressed to
g
ether with the air and this
could result in an ex
p
losion.
5. DO NOT USE A WRONG FITTING.
The connector on the tool must not hold
p
ressure when air su
pp
l
y
is
disconnected. If a wron
g
fittin
g
is used
,
the tool can remain char
g
ed with air
after disconnectin
g
and thus will be able to drive a fastener even after the
air line is disconnected
,
p
ossibl
y
causin
g
in
j
ur
y
.
6. DO NOT TOUCH THE TRIGGER UNLESS YOUR INTEND T
O
DRIVER A FASTENER.
Whenever the air su
pp
l
y
is connected to the tool
,
never touch the tri
gg
er
unless
y
ou intend to drive a fastener into the work. It is dan
g
erous to walk
around carryin
g
the tool with the tri
gg
er pulled, and this and similar actions
should be avoided.
7. NEVER POINT THE DISCHARGE OUTLET TOWARD YOURSELF
AND PERSONNEL.
If the dischar
g
e outlet is
p
ointed toward
p
eo
p
le
,
serious accidents ma
y
be
caused when misfirin
g
. Be sure the dischar
g
e outlet is not
p
ointed toward
p
eo
p
le when connectin
g
and disconnectin
g
the hose. Loadin
g
and not loadin
g
the fasteners or similar o
p
erations.
8. KEEP HANDS AND BODY AWAY FROM THE DISCHARGE OUTLE
T
When loadin
g
and usin
g
the tool
,
never
p
lace a hand or an
y
p
art of bod
y
in
fastener dischar
g
e area of the tool. It is very dan
g
erous to hit the hands or
body by mistake.
Sta
p
le S
p
ecification
W
ARNING: Be sure to use onl
y
the
g
enuine nails recommended for the
this nailer. The use of an
y
other nails can result in tool malfunction
,
leadin
g
to serious in
j
uries.