INSTANT PREPARATION MODE
• The instant preparation mode is the fastest mode for preparing bottles. Only
a few seconds are needed for the bottle to reach the right temperature (about
37°C).
• Fill the bottle with the necessary amount of water.
• Open the lid and pour the water into the heating unit.
• Close the lid.
• Press the button
. The button ashes during the heating process. Heating
time may vary depending on the amount of water and the initial temperature.
• As soon as the water has reached the correct temperature (about 37°C), the
button remains alight and the device beeps three times.
• Fill the bottle with the milk powder and place it on the container grid.
• Press down on the water distribution button until the bottle has been lled.
• Check that all the water has been emptied from the heating unit.
• A small amount of water may be left at the bottom of the heating unit. Dry it
with a clean cloth or tip the device forwards and press down on the water
distribution button until no water is left inside.
• To switch off the device, press the button again
.
ATTENTION! For hygiene reasons, the water distribution mode may
be used with water only.
BAIN-MARIE MODE
• Bain-Marie mode is for heating bottles and food jars.
• Always ensure that the device is unplugged and that the heating unit is empty
before removing the heating unit from its base.
• Open the lid of the heating unit.
• Fill the heating unit with water up to the “Max” line.
• Place the bottle or the jar to be heated in the heating unit.
• Press the button
or the button depending on the quantity to be
reheated and the food’s initial temperature:
Button 1: room temperature – small amount
Button 2: fridge temperature – large amount
• At the end of the heating cycle, the control button selected switches off and
the device beeps three times.
• Remove the bottle or the food jar with a cloth in order to avoid burns.
• After mixing the content of the food jar or shaking the bottle, always check that
To Next Page
Loading...
