the food is not too hot and that there is no risk of burning your child.
• In Bain-Marie mode, the product may be used with or without the base.
• To remove the heating unit from the base, remove the steriliser/bottle com-
partment.
• Remove the power cable from the cable storage compartment and turn the
heating unit’s unlocking button clockwise.
• Press down on the unlocking button and lift the heating unit from front to back.
CLEAN MODE
• For hygiene reasons, the device is tted with a self-cleaning function which
sterilises the device automatically.
• Pour about 100 ml of water into the heating unit.
• Close the lid and press the button
.
• At the end of the self-cleaning cycle, the button
switches off and the
device beeps three times.
• Wait a few minutes for the device to cool in order to avoid the risk of burns.
• Empty the contents of the heating unit into a suitable receptacle using the
water distribution button.
• Open the lid and clean the interior of the heating unit with a clean and dry cloth.
ATTENTION ! Never open the heating lid unit during a self-cleaning
cycle. Always wait 5 minutes after a self-cleaning
cycle before starting a new cycle.
STERILISER/BOTTLE COMPARTMENT
• Clean the bottles with hot soapy water and rinse well before sterilising.
• To sterilise your bottles in the microwave, place the bottles and the acces-
sories in the steriliser/bottle compartment. It is able to hold up to 3 bottles
depending on model and size.
• Fill the steriliser/bottle compartment with water up to the central mark (about
200 ml of water).
• Place the steriliser in the middle of the microwave oven.
• Select the heating time (4 mins for a 900 W oven and 6 mins for a 750 W to
800 W oven). Never exceed the recommended time.
• Once the sterilising cycle has ended, leave the steriliser to cool for 2 minutes
in the microwave oven in order to avoid the risk of burns.
• As soon as the device has cooled enough, open the lid to let the steam out.
To Next Page
Loading...
