Beaba Milk Prep - Cleaning and Maintenance; Cleaning Procedure

14
15
TROUBLESHOOTING
The warning light ashes
and the beep sounds
• The bowl is badly positioned on the base
• There is no water or milk in the bowl
• The bowl has been removed before the end of the cycle.
• The bowl has not been removed at the end of the cycle, the
temperature has continued to increase and is no longer at
the selected temperature.
The preparation is not at the
right temperature
• There is not enough milk or water in the bowl (heed 90 ml
minimum level)
• The preparation was not served immediately at the end of
the cycle
The mixture is not
homogeneous
• The water/powder dosage was not respected
If you need assistance or further information, please contact Béaba website (www.beaba.com)
or contact the Beaba Consumer Services.
ENVIRONMENT AND RECYCLING
•
Do not throw this product away with ordinary household waste. Enquire about the rules in
effect in your region concerning the selective collection of electric and electronic appliances.
Please contact your local authorities in case you need more information on the collection
points in your area.
2 times for a temperature of 37°C (bottle at body temperature).
3 times for a temperature of 48°C (warm milk, hot chocolate).
• Five beeps indicate the end of the cycle and the light ashes. Press the button once again to
stop the ashing light, then unplug the appliance.
• Lift the bowl by holding the handle and place it on a at surface.
• Lift the lid with the attached stirrer.
• Pour the preparation into a bottle or a recipient.
• Check the temperature and give it to your child.
Note: The warning light (
) will light up if the use of the product is incorrect (see table with
trouble shooting below).
Heat to 22°C Heat to 37°C Heat to 48°C
Approximate heating
time
1 to 3 minutes 1 to 4 minutes 2 to 6 minutes
CLEANING AND MAINTENANCE
• Before cleaning, unplug the appliance and allow it to cool down completely.
• Never immerse the housing in water to clean.
• Wash the bowl, the lid and the stirrer with water and soap or in the dishwasher.
• Do not use corrosive detergent, detergent with chemical powders or hard metal
• wire mesh to clean, as this will damage the appliance surface, affect the service
• life and cause safety problems.
• To avoid any risk of burns do not touch the heating element with your hands.
• When not in use, clean and dry the appliance, and then put it into the packaging box and store
in a dry place with good ventilation.
• If needed, ll the bowl with water and white vinegar or the Béaba descaler product for
Babycook (100ml white vinegar + 100ml water).
• Leave to soak until deposits have completely disintegrated (one night).
• Rinse with clear water several times.