Beam edition Series - Starting Up; Fill with Water; Settings and Controls

Look foward to it.
Starting Up Starting Up
4
Fill with water Settings
Attach hose
Fill the reservoir with
tap water.
Do not use distilled water, cleaning
agents, perfume or other chemical
substances.
Insert the plug on the
power cable into an earthed
Schuko socket.
Switch on the main switch.
Do not operate the switch with your
foot.
Fill the filter bowl with
tap water (up to the MIN.
mark).
Close the cover. Never
stand the appliance
upright.
Do not use distilled water.
Marking
separator plate
MIN = normal fill level
MAX = filter bowl full – suction
switches off
Insert the connector of the
steam suction hose into the
socket until the you hear
the click of the safety hook.
Do not suction flammable or
explosive substances or hot ash.
1
1a) 2a)
1b)
1c)
1d)
2
Press the “Suction” control
button 1 x
☞
to activate
the suction unit.
❹
❺
❻
2c)
Press the “Steam” control
button
☞
to heat up the
appliance.
❶ LED 1:
• Flashes during heat-up phase
• Stays on permanently once tempera-
ture is reached
❷ LED 2:
• Flashes when reservoir requires rell
• Flashes when lter bowl too full
• Flashes when hot water module
requires rell
❸ LED 3:
• Flashes while the soleplate heats up
• Stays on permanently once soleplate
is up to temperature
❷
❶
❸
2b)