What to do if pressure is not rising in my MC6 family calibrator from BEAMEX Test Equipment?
If you don’t see the pressure rising in your MC6 family calibrator even though the pump is running, check your connections. Ensure that you are connected to the correct pressure module, specifically the one selected as the Reference Module in Controller Presets.
Why does pressure generation stop, pressure vent, and the ePG switch off during BEAMEX Test Equipment calibration?
If the pressure generation stops during calibration, the pressure is vented, and the ePG switches off, it is likely that the ePG battery has run out. To resolve this, recharge the ePG battery to continue your work.
What to do if pressure generation stops during BEAMEX Test Equipment calibration but pressure is not vented?
If pressure generation stops during calibration, but the pressure isn't vented, ensure all cables are securely connected. The ePG will halt generation if the USB communication cable is removed.
General| Type | Multifunction Calibrator |
|---|---|
| Measurement Capabilities | Voltage, current, resistance, frequency, temperature, pressure |
| Calibration Capabilities | Pressure, Temperature, Electrical signals (Voltage, Current, Resistance, Frequency, Pulses) |
| Display | Color touchscreen |
| Power | Rechargeable battery |
| Operating Temperature | -10 °C to +50 °C |
| Power Supply | Battery or external power |
| Enclosure Rating | IP65 |
To Next Page
